To turn on the PA:
- Turn on the main power switch on the lower front of the PA cabinet
- Press the scan button on the mixing board to connect to the PA (Top right of the channel strip, round button, but push down)
- Turn on the PA speakers (light switch near the closet door closest to PA
- If the IPad doesn’t connect, you may need to restart the application and reconnect it by selecting the only option (Vowls)
To turn use the Bass
- Plug bass in
- Turn on the bass amplifier head in the lower section of the equipment rack
- Ensure volume on both bass and bass amplifier
To use Guitar amps
- Turn amp on in standby mode and let warm up for a minute or so
- Plugin in guitar
- Turn amp off of stand-by
- Adjust volume
To use the synth/piano:
- Power switch is on the back.
- Sound comes from the PA (so there will be no sound until you turn the PA on)
Leaving Checklist
- Turn down the main PA volume
- Turn off all power including PA speaker switches and PA rack cabinet
- Ensure room is clean and everything is back where you found it
- Turn Off Lights
- Close and Lock the door (Click the schlage button and twist the deadbolt)